| Subject | Text |
| Re: TV will not power up | [quote:17d6de0fe3="gilloz"]Take a look at your low voltage power supply. If it has a Bridge Rectifi |
| I think the standby power supply is a simple type of SMPS with a few watts of output?
If you have |
|
|
| Please help. Working on a sylvania srt2232s | Any assistance would be very helpful. We are working on a sylvania srt2232s. Sears bought this model |
| Service Manual for GoldStar GHV-1233p | Please can any one help me with a service manual for [b:2063d1c5cb][color=red:2063d1c5cb]GoldStar[/c |
| Toshiba TV 14R21 (PWB-1386 Board) keeps power on and off | [quote:b8bfe93703="minnie"]Chech r216 10k ohm to see if it's burnt. If so you need to replace the re |
| Bush tv (11ak45b5) Picture collaspe | Hi
I have been given a bush tv to have a look and and see if I can repair it. I am after so help |
| Wasjust looking over vtech's shoulder andfound a generic schematic to a power supply that should be |
| if main fuse blows,check diode bridge on small board at front where fuse is.otherwise front end powe |
| Possibility:
-Over voltage at C619 caused by:
* C at pin1 and pin2 STR81145A defective.
* STR81 |
| Looking for schematic for RCA DRC8335 VCR/DVD-R Combo. | Hi, the unit is RCA branded model DRC 8335B. The board that has the problem is actually the transpor |
| need service manuals | to whom it may concern...
hope i can need your help cos im in need of service manual of sony 20 |
| Pioneer VSx-5900S | I do not get anything on FM or AM but the Vu meter shows a received signal as they fluxuate on left |
| [quote:b54fb7477b="vtech"]Not familiar with the specific unit, some mechanism loop basics to check |
| Marconi TF 2700 | Does anybody have a usermanual for the Marconi R-L-C Bridge
[b:5e0cb55401]TF-2700[/b:5e0cb55401]. O |
| since you have a VOM/tester, set it to X1, be sure to discharge the largest capacitor u can find in |
| Just because a transformer has a mess of pins, does not mean it has to use all of them. :wink:
AC |
| Re: Display | "7) I then soldered back those 2 resistors and bridge wire."
Sounds like you're on the |
|
|
| Please check model of AIWA tape deck.
Model is AD-WX220 or WX220 ???? |
| Operational Manuel For Panasonic NV-HD750AM | Dear Friends,
If anybody have user/opertional manuel for Panasonic VCR Model (NV-HD750AM). Ple |
| Sony KV-35V45, Bad CRT. Looking for short... | Hi. I tought i would start a new topic, since i've focused my problem and my questions are different |
| NEC PX-42VP1G or 42PD1 or 42PD2 | hello. I have a problem with Power Board - not work at all. I changed the main Mofset and and check |
| Hi Raj,
Thanks for your reply. I powered up the amp and checked the voltage across the relay and |
| It's not a ctc chassis. The set was sold "as is " for junk by Wal-mart. It's less than a y |
| hi, i have spent some more time on this and have found that i dont have 240v a.c on the bridge recti |
| Service Manual HP6280 AIO Photosmart | Hi to all,
I have to disassemble the printer HP 6280 cause the printheads are blocks.
Could someon |
| Re: Renault Code | [quote:a1983f1861="khidma"]PART NAME: RADIO CAR
part Code: 281152928R
Model: LAN5210WR1
30848 |
| [quote:8046c12511="Anonymous"]Have you checked the horizontal output transistor for shorts?[/quote:8 |
| Beko 22.1 | I have a beko 22.1 chassis where 12V source (LD1086V) is running very hot. LD1086V is turning hot ve |
| If you need current feedback to get a correct waveform through an inductive load, please take a look |
| Check for power supply | yes! replace all the bad components but first isolate the problem before you power on. Also check yo |